[ICOM] IC-W31A

Mon May 2 08:04:23 EDT 2005

that helps alot Doug!!! that did it.  Dan

----- Original Message ----- 
From: "Doug Faunt N6TQS +1-510-655-8604" <faunt at panix.com>
To: <icom at mailman.qth.net>
Cc: <icom at mailman.qth.net>
Sent: Sunday, May 01, 2005 9:56 AM
Subject: Re: [ICOM] IC-W31A

> Hm, My notes say to hold Func, #, and B while turning on power.
>
> That gives you a new setting under the "SET" menu called "place",
> which can be 100, 10, or 1, indicating the first megaHertz position
> you can enter.
>
> Hope this helps,
> doug
>
>   Date: Sat, 30 Apr 2005 16:08:44 -0700
>   From: Gary Fiber <gfiber at comcast.net>
>
>   Lets see if I remember the correct way. Turn it off, press and hold the
>   Light, B and # keys while powering on the radio. It should now have 
> direct
>   frequency entry and open the receiver. Also the others suggestion about
>   mods.dk is good. Its been a while since I supported the W31A
>
>   Gary K8IZ
>
>   >I got the manual ok. When I got this talkie it was able to completely
>   >direst access freq's. I did a full reset and now it only does
>   >14-----   15-----
>   >etc. does anyone know the key mod to get the direct access back?  Dan
>
>   Gary Fiber K8IZ
>   GROL PG-19-6691
>   Washington State Resident
>
>
>   ----
>   Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
>   Icom Users Net: Sundays, 1700Z, 14.316 MHz
>   Icom FAQ: http://www.qsl.net/icom/
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/ 