[ICOM] AMP INTERFACE TO 756 PRO II

[MikeR]

Dan -
My PRO II manual says the relay can handle 16V @ 2 amps. I saw a lot of stuff on the web 
indicating that was a misprint, and the specs were much lower.  Take a look here: 
http://www.qsl.net/icom/auxrelay.html
There is apparently a lot of confusion about the relay in the PRO line. I use a buffer. 
It's cheap insurance.
73, Mike NF4L

Dan Coleman W8KMX wrote:
> I want to interface an Ameritron ALS-600 to an ICOM 756 Pro II.  Has 
> anyone done this and is there any special hookup that is needed?
> Dan
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>