[ICOM] Icom PW-1 Failures - How To

[Mike McCarthy, W1NR]

Better read the manual.  It states NOT to use the rig's internal tuner when
using the PW-1!

Mike, W1NR 

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Bruce J. Howes
Sent: Wednesday, June 08, 2005 12:02 AM
To: 'ICOM Reflector'
Subject: RE: [ICOM] Icom PW-1 Failures - How To

Icom 765 and resonant 160 meter dipole.

Something is not right about the nature of this failure, even if it did have
a mismatch it should not repeatly damage the resistor.

Seems the fault occurs when the rig tuner, not the PW-1's tuner is used.

Bruce W1UJR 

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Mike Mellinger WA0SXV
Sent: Tuesday, June 07, 2005 9:07 PM
To: 'ICOM Reflector'
Subject: RE: [ICOM] Icom PW-1 Failures - How To

That must be quite a load.  What are you running for an exciter and antenna?

Mike


-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Bruce J. Howes
Sent: Tuesday, June 07, 2005 19:31
To: icom at mailman.qth.net
Subject: [ICOM] Icom PW-1 Failures - How To

Guess you just can not use the rig's internal antenna tuner with the PW-1.
Zorched the SWR resistor again, R7.
 
Poor design.
 
73 Bruce W1UJR


----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net Icom Users
Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/



----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net Icom Users
Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/