[ICOM] IC-2710H Transmit Audio Too Hot

[D C Macdonald]

Call Icom.  They will send you a surface mount
resistor of 560 Ohm value that your use to
replace an existing resistor on the board in the
microphone.  Ask them to send you a 470 and
430 Ohm also.  I put the 560s in my two 2710s
and it helped tremendously, but not quite enough
for my big mouth.

73  ---  Mac, K2GKK/5



----Original Message Follows----
From: "John Chesley" <jvc749 at adelphia.net>
Reply-To: ICOM Reflector <icom at mailman.qth.net>
To: "'ICOM Reflector'" <icom at mailman.qth.net>
Subject: [ICOM] IC-2710H Transmit Audio Too Hot
Date: Sat, 29 Jan 2005 22:34:25 -0500

The microphone on my IC-2710H mobile is overdriving the radio.  The mic is
so sensitive that I have to hold it 1 foot away to get reasonable transmit
audio levels.  I have verified this on a service monitor.  Since I do not
have a service monitor for the rig, can anyone tell me what trimmer or
control inside of the radio to adjust to set the transmit audio levels back?

Thanks.

John, AK3Z
----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
Win a new Icom IC-756 PRO III and help QSL/QTH.net
Details at: http://mailman.qth.net/