[ICOM] Fw: PROII & SB200

[Doug Renwick]

I use a slightly modified Yaesu FRB-757 relay box (semi bk-in).

Doug

Adam Farson wrote:

> Hi Matt,
> 
> This topic is extensively covered here:
> 
> http://www.qsl.net/icom/auxrelay.html
> 
> If you wish to build an interface, you should use an auxiliary relay with a
> contact rating sufficient to switch the -135V/3A keying line of the SB-200.
> The relay coil should be rated at 12V, with operate current less than 0.5A
> and a snubbing diode across the coil. I would recommend a transistor relay
> driver. There are also several commercially-built options available, as
> discussed in the above link.
> 
> Cheers for now, 73,
> Adam VA7OJ/AB4OJ
> 
> 
> -----Original Message-----
> From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
> Behalf Of mparkinson1
> Sent: 21 February 2005 15:23
> To: ICOM Reflector
> Subject: Re: [ICOM] Fw: PROII & SB200
> 
> Funny I am looking for some thing to use to patch between my Pro lll and my
> SB-200.
> I am new to the Ham world and I am a tech but need the equipment to isolate
> the transiever from the SB-200 so I won't fry something.
> Matt

-- 
Doug Renwick VA5DX
PO Box 50, Clavet, Saskatchewan, Canada S0K 0Y0
VE5RA at sasktel.net
First VE5 5BDXCC, 160M DXCC & 9BDXCC
What profit it a ham if he gains all the awards yet forfeits his soul?
I'll run the race and I will never be the same again.