[ICOM] PW-1 Amp

[Jerry Keller]

Standby Mode? The PW-1 has a Standby Mode? I've just been using the main power switch in the upper 
left of the control panel to turn it on and off. Maybe that's what has escaped me, Adam.... how do I 
engage the Standby Mode?

Jerry K3BZ

----- Original Message ----- 
From: "Adam Farson" <farson at shaw.ca>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Wednesday, October 20, 2004 10:28 PM
Subject: RE: [ICOM] PW-1 Amp


> Hi Jerry,
>
> It probably does not make much difference either way. You could leave the
> PW1 powered up, but in standby mode when not operating high-power.
>
> Cheers for now, 73,
> Adam VA7OJ/AB4OJ
>
>
> -----Original Message-----
> From: icom-bounces at mailman.qth.net
> [mailto:icom-bounces at mailman.qth.net]On Behalf Of Jerry Keller
> Sent: Wednesday, October 20, 2004 13:55
> To: (Reflector) ICOM; (Reflector) ICOM Yahoo
> Subject: [ICOM] PW-1 Amp
>
>
> I leave the 756ProII on all day and run barefoot most of the time. If I
> power up the PW-1 in the
> morning for some DX, is it better to leave it on while I'm just listening
> (just in case I need it)
> or should I power it down? IOW, is there significant "wear & tear" on a PW-1
> when it's on but not
> transmitting?
> Or, should I power it down after each use and power it up again each time I
> need it?
>
> 73,  Jerry K3BZ
>
>
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
>
> Scanned by WinProxy
> http://www.Ositis.com/
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>