[ICOM] PW-1 Amp

[Adam Farson]

Hi Jerry,

It probably does not make much difference either way. You could leave the
PW1 powered up, but in standby mode when not operating high-power.

Cheers for now, 73,
Adam VA7OJ/AB4OJ


-----Original Message-----
From: icom-bounces at mailman.qth.net
[mailto:icom-bounces at mailman.qth.net]On Behalf Of Jerry Keller
Sent: Wednesday, October 20, 2004 13:55
To: (Reflector) ICOM; (Reflector) ICOM Yahoo
Subject: [ICOM] PW-1 Amp


I leave the 756ProII on all day and run barefoot most of the time. If I
power up the PW-1 in the
morning for some DX, is it better to leave it on while I'm just listening
(just in case I need it)
or should I power it down? IOW, is there significant "wear & tear" on a PW-1
when it's on but not
transmitting?
Or, should I power it down after each use and power it up again each time I
need it?

73,  Jerry K3BZ



----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/


Scanned by WinProxy
http://www.Ositis.com/