[ICOM] 756Pro Alinement

[Ken]

Yes I like this method - Before I touch the R32 I can check all the bands
and see if they are all the same or not.  By "ear" some of the bands sounded
different amount off, but my hearing isn't as good as it could be.

AND setting to 756Pro to show the 1hz resolution is a good idea.  Glad you
mentioned it Larry,

I sure like this reflector!!  Thanks ya'll.

Ken H>

----- Original Message ----- 
From: "Larry Benko" <w0qe at bnk.com>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Tuesday, May 25, 2004 11:09 AM
Subject: Re: [ICOM] 756Pro Alinement


> Ken,
>
> Well since you already have Digipan set up you are 90% of the way done.
> One more thing before you adjust R32.  You can hold down the TS button
> on the 756Pro show the "Hz" digit displays and slightly adjust the
> tuning dial until the USB and LSB waterfalls agree.  Then you will know
> exaclty how far off frequency you are.  Let me know the answer.
>
> 73,
> Larry, W0QE
>
> Ken wrote:
>
> >Thanks Larry, this sounds like something I can do.  I have digipan (I
think
> >v1.7) on the computer with an interface I use for PSK.
> >
> >I will be checking this version.  My hearing isn't as good as it should
be
> >and I was concerned about being able to tell with the tones with the
> >alignment procedure were correct.  With the program I can "see" the
correct
> >tone setting.
> >
> >Yes, I'm sure it's only the R32 for fine adjustment required.
> >
> >Thanks again,
> >
> >Ken H>
> >
> >
> >
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>