[ICOM] 756Pro Alinement

Ken k9fv at highstream.net
Tue May 25 09:02:35 EDT 2004


Good morning Ron, and thank you for your response.

You are correct, the signal will shift when switching from AM to LSB and to
USB, but it should shift the same amount - it doesn't.  It's only a small
amount, but you can actually tell it from the bandscope, but hearing it is
more telling.  For normal CW (or SSB) it's not enough to cause a problem,
but when working the digital modes, it is more telling.

Any ideas?

Ken
----- Original Message ----- 
From: "Ron Lowrance, K4SX" <k4sx at akorn.net>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Tuesday, May 25, 2004 7:52 AM
Subject: Re: [ICOM] 756Pro Alinement


> When tuning the WWV signals on 5, 10, and 15MHZ the typical mode is AM.
You
> will notice that the AM signal is centered on the center line of your
> display.  When you change to LSB the signal will shift one direction and
the
> opposite for USB.  If I understand your question correctly and your radio
is
> behaving in the manner just described, so your radio is operating
properly.
> If I missed your point please send me an email.
>
> K4SX
> Ron Lowrance
> Cumming, GA
>
>
>
>
>
> ----- Original Message ----- 
> From: "Ken" <k9fv at highstream.net>
> To: <icom at mailman.qth.net>
> Sent: Tuesday, May 25, 2004 8:42 AM
> Subject: [ICOM] 756Pro Alinement
>
>
> Hi all,
>
> I have a 756Pro that seems to be out of alignment.  If I tune in 10.000mhz
> on AM, then switch to USB then LSB, shouldn't the sound be the same on
both
> LSB and USB?  It is not.  I've checked at 10, 15, and 20mhz on the WWV
freqs
> and USB/LSB tone is off on all bands, but amount of tone off varies per
> band.
>
> I looked at the ICOM alignment procedure in the manual, but was told by a
> couple of folks that would not do the alignment I needed.  Is this true?
OR
> would this  procedure work?
>
> I would like to find a repair should within a couple of hundred miles of
> Mobile, AL so I could perhaps take the rig in one morning, and pick it up
> that afternoon if at all possible.
>
> Thanks for any info/help anyone can provide.
> Ken H>
> K9FV
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>



More information about the Icom mailing list