[ICOM] IC 756 Display and N4PY Software

[MikeR]

Ekki -
The 756 is the only ICOM manual I've seen so far with a truncated command
set. You and your website have been invaluable to me in my programming.
Again, thanks!!
Mike NF4L
----- Original Message ----- 
From: "Ekki Plicht" <ep at plicht.de>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Saturday, June 12, 2004 7:49 AM
Subject: Re: [ICOM] IC 756 Display and N4PY Software


> On Thursday 10 June 2004 22:43, MikeR wrote:
> > Vielen dank Ekki -
> > The manual oddly does not list the "read" commands and I don't have one
to
> > practice with. So it'll be the old FEFE addr03 and 04 then?
> > 73, Mike NF4L
>
> The manual doesn't list the commands? Odd... they are the most
standardized
> commands, found on any rig which supports CI_V. 0x03 is for reading the
> frequency, 0x04 is for reading the mode/filter setting.
>
> So:
> FE FE (to) (fm) 03 FD
> reads the currently displayed frequency. Answer from rig is
> FE FE (to) (fm) 03 xx xx xx xx xx FD
> (xx) are the frequency information.
>
> FE FE (to) (fm) 04 FD
> reads the currently displayed mode and filter setting. Answer from rig is
> FE FE (to) (fm) 04 xx yy FD
> (xx) is the mode byte, (yy) is the filter byte.
>
> FE FE (to) (fm) 05 xx xx xx xx xx FD
> writes frequency data (xx) to the currently selected VFO. Answer from rig
is
> FE FE (to) (fm) FB FD
> if all was ok, otherwise FE FE (to) (fb) FA FD
>
> FE FE (to) (fm) 06 xx yy FD
> write mode (xx) and filter (yy) to the currently selected VFO. Answer from
rig
> is
> FE FE (to) (fm) FB FD
> if all was ok, otherwise FE FE (to) (fb) FA FD
>
>
> 73,
> Ekki, DF4OR
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>