[ICOM] IC 756 Display and N4PY Software

[Ekki Plicht]

On Thursday 10 June 2004 22:43, MikeR wrote:
> Vielen dank Ekki -
> The manual oddly does not list the "read" commands and I don't have one to
> practice with. So it'll be the old FEFE addr03 and 04 then?
> 73, Mike NF4L

The manual doesn't list the commands? Odd... they are the most standardized 
commands, found on any rig which supports CI_V. 0x03 is for reading the 
frequency, 0x04 is for reading the mode/filter setting.

So:
	FE FE (to) (fm) 03 FD
reads the currently displayed frequency. Answer from rig is 
	FE FE (to) (fm) 03 xx xx xx xx xx FD
(xx) are the frequency information.

	FE FE (to) (fm) 04 FD 
reads the currently displayed mode and filter setting. Answer from rig is
	FE FE (to) (fm) 04 xx yy FD
(xx) is the mode byte, (yy) is the filter byte.

	FE FE (to) (fm) 05 xx xx xx xx xx FD
writes frequency data (xx) to the currently selected VFO. Answer from rig is
	FE FE (to) (fm) FB FD 
if all was ok, otherwise FE FE (to) (fb) FA FD

	FE FE (to) (fm) 06 xx yy FD
write mode (xx) and filter (yy) to the currently selected VFO. Answer from rig 
is
	FE FE (to) (fm) FB FD 
if all was ok, otherwise FE FE (to) (fb) FA FD


73,
Ekki, DF4OR