[ICOM] PW-1 problem

[Steve N4LQ]

You do need to set the speed to 9600 bps on the PROII so it can talk to the 
PW1 then go through the resetting procedure on the PW1 console. Also try 
plugging the pw1 directly into the PRO to eliminate possibility of CT-17 
problems....just to check things out. Finally, I believe you must set the 
menu on the PRO for IC735 transcieve, or at least I did here.

Steve N4LQ
----- Original Message ----- 
From: "Chuck Kresge" <du3nxe at mozcom.com>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Wednesday, December 29, 2004 12:26 PM
Subject: [ICOM] PW-1 problem


>I need some help with my new PW-1.
>
> I have an IC-756PROII and just received a PW-1 amplifier. During the
> separation of the remote controller from the amplifier I noticed on page 
> 10
> of the PW-1 manual in step 8 it says "Connect the grounding wire as shown
> below." I never could find that grounding wire and cannot see it in the
> illustration and then continued to complete the separation of the remote
> controller. My amplifier is working with my IC-756PROII except that I 
> cannot
> get the amplifier to automatically change bands with the PW-1 and my CT-17
> installed with my computer.
>
> Can someone give me information on this grounding wire?
>
> Thanks very much-Chuck Kresge DU3NXE du3nxe at mozcom.com
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Win a new Icom IC-756 PRO III and help QSL/QTH.net
> Details at: http://mailman.qth.net/
>