[ICOM] PW-1 problem

[Adam Farson]

Hi Chuck,

The following link gives the 756Pro/PW1/CT17 setup procedure. It should work
for the Pro2 as well.

http://www.icomamerica.com/support/documents/pw1-756.asp

As for the grounding wire: From the sketch in the user manual, this appears
to be a short bare wire coming out of the plug  (on the short jumper) which
connects to J11. This wire should be connected to a point on the chassis
frame, although that is not at all clear from the sketch. I do not own a
PW1, so am only extrapolating (and guessing) from the user manual.

Hope this helps.

Cheers for now, 73,
Adam VA7OJ/AB4OJ


-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Chuck Kresge
Sent: 29 December 2004 09:26
To: ICOM Reflector
Subject: [ICOM] PW-1 problem

I need some help with my new PW-1.

I have an IC-756PROII and just received a PW-1 amplifier. During the
separation of the remote controller from the amplifier I noticed on page 10
of the PW-1 manual in step 8 it says "Connect the grounding wire as shown
below." I never could find that grounding wire and cannot see it in the
illustration and then continued to complete the separation of the remote
controller. My amplifier is working with my IC-756PROII except that I cannot
get the amplifier to automatically change bands with the PW-1 and my CT-17
installed with my computer.

Can someone give me information on this grounding wire?

Thanks very much-Chuck Kresge DU3NXE du3nxe at mozcom.com

----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net Win a new
Icom IC-756 PRO III and help QSL/QTH.net Details at: http://mailman.qth.net/


Scanned by WinProxy
http://www.Ositis.com/