[ICOM] IC-207H Scanning

[Gary Fiber]

Looks like you start the scan in VFO mode,  then while its scanning you 
press the band button momentarily to cycle through full band or P1 to P5 to 
select which pair of programmed scan " channels " you desire to scan. Once 
you press the band button lets say a few times and stop at P3 then the 207H 
should be scanning between what you programmed into 3A and 3b. remember 
there has to be a difference in frequency between 3A and 3b or the 207H 
will not scan. Page 39 of the 207H manual tells how to operate the 
programmed scan.

Gary K8IZ

At 05:44 PM 8/6/2004, you wrote:
>I have programmed 5 sub-bands to search using the band edge feature.Each 
>sub-band has a memory location but I cannot figure out how to call up 
>these memory locations to scan each sub-band separately.The band scanning 
>and VFO scanning work just fine.
>
>I can't seem to find the procedure in the book
>
>Any help would be appreciated.
>
>73,
>Bob
>W0OXJ
>----
>Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
>Icom Users Net: Sundays, 1700Z, 14.316 MHz
>Icom FAQ: http://www.qsl.net/icom/

Gary Fiber K8IZ
GROL PG-19-6691
Washington State Resident