[Icom] IC-PW1 Help

Thu, 10 Jul 2003 11:54:06 -0500

I'll look at my manual when I get home tonight.  If you haven't gotten any
other good answers, I'll see if I can help.  I just followed my instructions
and didn't have any questions.  I'll see what mine says - can't remember
now!  HI

----- Original Message ----- 
From: "Ken Kinyon - W7TS" <[email protected]>
To: <[email protected]>
Sent: Thursday, July 10, 2003 11:42 AM
Subject: [Icom] IC-PW1 Help

>
> Hi,
> I asked this once before with no response, so I will rephrase it and try
> again.
> Below is a quote from Page 10 (Bottom  right) of PW1 manual, under
> separating the remote controller.
>
> "Plug the other longer end (from the bushing) of the
> separation cable into J10 on the JACK unit through
> the cable hole. Connect the grounding wire as
> shown below. Connect the control cable to J11."
>
> I do not understand the sentence "Connect the grounding wire as
> shown below".  There is no grounding wire on the cable, and I don't see
> anything in the illustration below the shows a grounding wire.
>
> How did the rest of you handle this?
>
> For now, I'm disregarding it, somewhat uneasily.
>
> Thanks, Ken W7TS
>
> -------------------
> Kenneth E.  Kinyon
> 34 Princeton Circle
> Longmont, CO 80503-2106
> Voice: (303) 684-0037
> Fax:  (303) 776-5088
> E-mail: [email protected]
>   [email protected]
>   [email protected]
> ALPCA #8339
> ARRL-LM
> -------------------
>
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom Users Net: Sundays, 1700Z, 14.315 MHz
> Icom FAQ: http://www.qsl.net/icom/
>