[Icom] Ic-756ProII Problems

Sat, 11 Jan 2003 14:48:16 -0500

Did you try disconnecting the mic to make sure it's not a short in the 
mic/cable/connector?

Do you have any digital gear hooked up, like a TNC etc? Disconnect 
everything but the power cord and a dummy load. Does it still come up in 
xmit?

Roland Guidry - WA5CHX wrote:

> Thanks for reply Jim, I never touched it, but have depressed it several
> times to no avail. I have also held it down for a few seconds for whatever
> that may do!
> 
> Sic!
> 
> Roland, WA5CHX
> 
> ----- Original Message -----
> From: "jim fox" <[email protected]>
> To: <[email protected]>
> Sent: Saturday, January 11, 2003 10:59 AM
> Subject: Re: [Icom] Ic-756ProII Problems
> 
> 
> 
>>CHECK RIGHT UNDER THE ON-OFF SWITCH.. THE BUTTON LABELED XMIT- MAKE SURE
>>
> IT
> 
>>DIDN'T GET PUSHED BY ACCIDENT..  JIM / W0HFG
>>
>>
>>>From: "Roland Guidry - WA5CHX" <[email protected]>
>>>Reply-To: [email protected]
>>>To: <[email protected]>
>>>Subject: [Icom] Ic-756ProII Problems
>>>Date: Sat, 11 Jan 2003 10:30:12 -0600
>>>
>>>I was operating CW and when I quit transmitting the receiver went into
>>>receive mode and then a few seconds later went into transmit mode. I was
>>>operating barefoot. I disconnected all cables to PC and reset the CPU in
>>>the
>>>radio to no avail. Doesn't this always happen on a Saturday. Does anyone
>>>have any ideas? Otherwise less than 1 yr old Pro goes in for warranty
>>>
> work.
> 
>>>Any advice if I should send direct to ICOM in WA or use one of their
>>>service
>>>centers in Louisiana.
>>>
>>>Roland, WA5CHX
>>>
>>>
>>>----
>>>Your Moderator: Dick Flanagan W6OLD, [email protected]
>>>Icom Users Net: Sundays, 1700Z, 14.315 MHz
>>>Icom FAQ: http://www.qsl.net/icom/
>>>
>>
>>_________________________________________________________________
>>Help STOP SPAM: Try the new MSN 8 and get 2 months FREE*
>>http://join.msn.com/?page=features/junkmail
>>
>>----
>>Your Moderator: Dick Flanagan W6OLD, [email protected]
>>Icom Users Net: Sundays, 1700Z, 14.315 MHz
>>Icom FAQ: http://www.qsl.net/icom/
>>
>>
> 
> 
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom Users Net: Sundays, 1700Z, 14.315 MHz
> Icom FAQ: http://www.qsl.net/icom/
> 
> 