[Icom] Ic-756ProII Problems

Sat, 11 Jan 2003 11:03:56 -0600

Jerry, I guess I wasn't clear. The Pro2 stays in transmit mode always. When
I turn it off and back on it is in transmit mode. So reliably is not the
issue here. Hi!

Roland

----- Original Message -----
From: "Jerry Flanders" <[email protected]>
To: <[email protected]>
Sent: Saturday, January 11, 2003 10:50 AM
Subject: Re: [Icom] Ic-756ProII Problems

> Unless you can find a way to actually demonstrate this reliably, and tell
> the service center just how to make it show up, you are probably wasting
> your time to send it in for service. Been there, done that, learned lesson
> (though from a different company).
>
> Jerry W4UK
>
> At 10:30 1/11/03 -0600, you wrote:
> >I was operating CW and when I quit transmitting the receiver went into
> >receive mode and then a few seconds later went into transmit mode. I was
> >operating barefoot. I disconnected all cables to PC and reset the CPU in
the
> >radio to no avail. Doesn't this always happen on a Saturday. Does anyone
> >have any ideas? Otherwise less than 1 yr old Pro goes in for warranty
work.
> >Any advice if I should send direct to ICOM in WA or use one of their
service
> >centers in Louisiana.
> >
> >Roland, WA5CHX
>
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom Users Net: Sundays, 1700Z, 14.315 MHz
> Icom FAQ: http://www.qsl.net/icom/
>