[Icom] Ic-756ProII Problems

Sat, 11 Jan 2003 16:55:24 -0000

Roland, you might check out Avvid in Irving, TX. Clif is factory authorized
for Icom and Kenwood, and that is where I send anything that needs fixed. He
just fixed my 746 (display problem) and I think turn around is about 4-5
weeks now. I'm sure there are other good repair centers, but I've had good
luck with Clif. The web address is:
http://www.avvid.com/

73 - Mike K9MI

----- Original Message -----
From: "Roland Guidry - WA5CHX" <[email protected]>
To: <[email protected]>
Sent: Saturday, January 11, 2003 4:30 PM
Subject: [Icom] Ic-756ProII Problems

> I was operating CW and when I quit transmitting the receiver went into
> receive mode and then a few seconds later went into transmit mode. I was
> operating barefoot. I disconnected all cables to PC and reset the CPU in
the
> radio to no avail. Doesn't this always happen on a Saturday. Does anyone
> have any ideas? Otherwise less than 1 yr old Pro goes in for warranty
work.
> Any advice if I should send direct to ICOM in WA or use one of their
service
> centers in Louisiana.
>
> Roland, WA5CHX
>
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom Users Net: Sundays, 1700Z, 14.315 MHz
> Icom FAQ: http://www.qsl.net/icom/

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.443 / Virus Database: 248 - Release Date: 1/10/2003