[Icom] RE: Re: Low pass filter

Sun, 27 Oct 2002 13:54:05 +0100

Hello Sasi,

One last advise; always keep the connection between the transmitter of
SWR/power-meter and the low-pass filter as short as possible! A double male
connector would be a good solution.

Good luck and 73!

Hans Remeeus.

Ham Radio:
PA1HR

Sites:
www.remeeus.nl
www.qsl.net/pa1hr

e-mail:
[email protected]

----- Original Message -----
From: "sasi nayar" <[email protected]>
To: <[email protected]>
Sent: Saturday, October 26, 2002 11:50 AM
Subject: [Icom] RE: Re: Low pass filter

> Thanks everyone for your suggestions. Bencher seemed
> to be an obvious choice. Soo after I posted the
> message I managed to lay my hands on a old yaesu LPF.
> Tried it and everything was fine except 6m. I just
> finished reading Joe's point and its very valid. My
> AH4 wouldnt tune on 6m.
>
> Now that I have some pointers, I shall browse around a
> bit and get somemore info.
>
> Thanks again every one. Awesome list.
> 73 and hoping to work some of you at the contest.
> Sasi
> VU3SNM / 9V1SM
>
> =====
> Amateur Radio For Global Peace and Fraternity
> ----------------------------------------------
> Sasi Nayar, 9V1SM / VU3SNM,
> Reef Ecology Lab, Department of Biological Sciences
> National University of Singapore,14 Science Drive 4
> Singapore 117 543. Tel : (65) 6778 7112
URL:http://www.dbs.nus.edu.sg/lab/reef/SasiNayar.htm
>
> __________________________________________________
> Do you Yahoo!?
> Y! Web Hosting - Let the expert host your web site
> http://webhosting.yahoo.com/
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom Users Net: Sundays, 1700Z, 14.315 MHz
> Icom FAQ: http://www.qsl.net/icom/
>