[Icom] ICOM Service Center Problem

[Larry Winslow]

Please excuse if I speak about the obvious.

It seems to me that report from Icom that the problem has to be some where=
=20
with your coax or the antenna. Have you tried putting an ohm-meter across=20
the center pin to the shield to see if there's a short? Have you tried=20
another antenna and/or coax?

I'm just throwing out random thoughts.

73 - Larry W=D8NFU



At 11:31 AM 10/24/2002 -0700, you wrote:
>Hello All,
>
>I sent my ICOM 706 MKII G for warranty repair to ICOM to correct a problem
>where, when  I insert the center piece and start screwing on the shield,=
 the
>signal drops appreciably from maybe an S5 noise level to S1, if at all. My
>antenna and coax is Ok. Tried the rig on my friends resonant antenna and
>problem is there as well.
>
>ICOM is returning the rig to me, saying that they tested it and it works=
 fine.
>I suggested they check SO-239 connector to make sure and they said it was
>fine.
>
>So my question is: what do I do now? I do believe them, but there=
 definitely
>is something wrong with the rig. Were the techs there just being lazy?
>
>Any ideas?.
>
>----
>Your Moderator: Dick Flanagan W6OLD, icom-owner@mailman.qth.net
>Icom Users Net: Sundays, 1700Z, 14.315 MHz
>Icom FAQ: http://www.qsl.net/icom/