[Icom] 761 battery replacement

Thu, 16 May 2002 09:16:00 -0400

The 761 DOES NOT use a ram board.
At 06:06 AM 5/16/02 -0700, you wrote:
>John
>Thanks for the tip about the PIEXX RAM module.  Have you any experience with
>this particular one?  Have you installed it?  Does it extend the RX range
>like the Willco board does?
>
>
>Regards
>Jim Shaw
>[email protected]
>www.ShawResources.com
>408-973-1608
>
>-----Original Message-----
>From: [email protected] [mailto:[email protected]]On
>Behalf Of John L Merrill
>Sent: Saturday, May 11, 2002 7:11 AM
>To: [email protected]
>Subject: RE: [Icom] 761 battery replacement
>
>
>If you change the battery on the 761 you must devise a way of keeping 3volts
>to that module. Otherwise, not only will you lose memories but the operating
>system of the radio. Then you would have to send it off to ICOM for
>reprogramming. For $70 bucks, I would recommend buying a new ram module from
>PIEXX www.piexx.com and you wouldnt have to worry about that problem again.
>
>John N1JM
>
>-----Original Message-----
>From: [email protected] [mailto:[email protected]]On
>Behalf Of Julio
>Sent: Saturday, May 11, 2002 9:48 AM
>To: [email protected]
>Subject: [Icom] battery replacement
>
>
>Planning on changing the batteries in an IC-735 & 761 today.
>Anything caveats?
>
>
>----
>Your Moderator: Dick Flanagan W6OLD, [email protected]
>Icom FAQ: http://www.qsl.net/icom/
>---
>Incoming mail is certified Virus Free.
>Checked by AVG anti-virus system (http://www.grisoft.com).
>Version: 6.0.361 / Virus Database: 199 - Release Date: 5/7/2002
>
>----
>Your Moderator: Dick Flanagan W6OLD, [email protected]
>Icom FAQ: http://www.qsl.net/icom/
>
>----
>Your Moderator: Dick Flanagan W6OLD, [email protected]
>Icom FAQ: http://www.qsl.net/icom/