[Icom] Display on Pro II question...

Sun, 5 May 2002 19:44:15 -0400

Good golly Paul..I don't keep up with that...I just wanted to make sure it
was not a trend or signs of a beginning problem. You sure have been quiet
about that JRC radio. I sold my Alpha 91B and if everything goes ok...I
picked up an Alpha 99 with 3-1/2 years warranty left on it. Man I hate
boxing that thing up though. Take care and I hope you are doing well. 73,
Steve, NX1G

----- Original Message -----
From: "paul" <[email protected]>
To: <[email protected]>
Sent: Sunday, May 05, 2002 2:54 PM
Subject: Re: [Icom] Display on Pro II question...

> steve..  what is your room temp?  the screen is very sensitive to small
temp
> changes..  i have heard of other folks having the same problem  73  paul
> w8jn
> ----- Original Message -----
> From: "Steve Jones" <[email protected]>
> To: <[email protected]>
> Sent: Sunday, May 05, 2002 12:17 PM
> Subject: [Icom] Display on Pro II question...
>
>
> > When I turn on my Pro II...sometimes the screen stays blank or black
until
> > it has almost finished it's digital calibration. Sometimes it pops right
> up
> > and sometimes a solid gray screen comes up and then it goes to the
> > calibration screen mode. Anyone else have this problem and is it
something
> > to worry about. If the question has been answered before..please Email
me
> > direct at [email protected], 73, Steve
> >
> >
> > ----
> > Your Moderator: Dick Flanagan W6OLD, [email protected]
> > Icom FAQ: http://www.qsl.net/icom/
> >
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom FAQ: http://www.qsl.net/icom/
>