[Icom] PW-1

Thu, 21 Feb 2002 09:38:03 -0500

Julio,

On my PW-1, the remote unit already had four plastic feet that were cemented
into indentations on the bottom of the remote. The two plastics disks (they
look a little like grommets - with ridges, but not any adhesive - right?)
were hole plugs for covering the two holes on the rear of the remote, in the
bottom right and left corners.

-larry
K8UT
----- Original Message -----
From: "Julio" <[email protected]>
To: <[email protected]>
Sent: Thursday, February 21, 2002 9:21 AM
Subject: Re: [Icom] PW-1

> On my remote the disks and strip you mention are felt material and they
are
> in place as you mention. The rubber feet were in a plastic bag with a
couple
> of screws and a ground lug.
>
> Julio
> ----- Original Message -----
> From: "WA9ALS - John" <[email protected]>
> To: <[email protected]>
> Sent: Thursday, February 21, 2002 7:56 AM
> Subject: RE: [Icom] PW-1
>
>
> > > There are 2 rubber disks that are included with the PW1. The
> > > instruction manual lists them as feet for the remote.
> > >
> > > Anybody figure out where they are supposed to install? The
> > > only place I could figure to put them was in the slotted area
> > > of the bottom case screws.
> >
> > My remote has 4 round rubber disks and a rubber strip that runs all
> > along the front edge.  The round rubber disks are NOT over the slotted
> > area.  The round disks were already there - I didn't install them.
> >
> > ? Maybe 2 of your 4 fell off and were thus found in the package?
> >
> > ----
> > Your Moderator: Dick Flanagan W6OLD, [email protected]
> > List Archives : http://mailman.qth.net/pipermail/icom/
> > List Control  : http://mailman.qth.net/mailman/listinfo/icom/
> >
>
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> List Archives : http://mailman.qth.net/pipermail/icom/
> List Control  : http://mailman.qth.net/mailman/listinfo/icom/
>