[Icom] Does the new Icom Pro require
Julio
[email protected]
Mon, 18 Feb 2002 06:36:39 -0500
I think what some others are trying to say is this problem has already been
solved here. For what ever reason there is incorrect information in the 756
manuals. If you use an amp that has a keying circuit that demands more that
12 - 16 volts DC at more than 200 Ma. You stand a good chance of damaging
the small switching relay in the 756, 756 PRO, PRO II.
Julio
----- Original Message -----
From: "w3jo" <[email protected]>
To: <[email protected]>
Sent: Sunday, February 17, 2002 5:48 PM
Subject: Re: [Icom] Does the new Icom Pro require
> Why gamble on such a potential problem. Does anyone think that maybe just
a
> simple phone call to Icom would bring an answer before trying to place it
in
> a circuit, instead of trying to solve it here? Good luck
>
> Joe...W3JO
>
>
>
> > Might be just a rumor then - if it was real, ICOM should have corrected
it
> > or acknowledged it by now. Anybody know the source of this?
> >
> > There is no mention of a keying current typo in the Feb 2002 QST writeup
> of
> > the PRO-II or the extended test report (I just looked).
> e specs of the relay at
> > the OEM site?
> >
> > Jerry W4UK
> >
> > At 11:20 AM 2/17/2002 -0600, George, W5YR wrote:
> > >I don't know, Jerry, since Icom to my knowledge has never admitted to
> the
> > >typo in either manual. In fact, a most interesting question would be
what
> > >would Icom do about a relay on a radio in warranty that was welded due
to
> > >trying to pass up to 2 amps through it?
> > ><SNIP>
> > >
> > >Jerry Flanders wrote:
> > > >
> > > > Does ICOM say it is a misprint? Where can I read what they say on
this
> > > > subject?
> > > >
> > > > Jerry W4UK
> > >
> > >---
> >
> > ----
> > Your Moderator: Dick Flanagan W6OLD, [email protected]
> > List Archives : http://mailman.qth.net/pipermail/icom/
> > List Control : http://mailman.qth.net/mailman/listinfo/icom/
> >
>
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> List Archives : http://mailman.qth.net/pipermail/icom/
> List Control : http://mailman.qth.net/mailman/listinfo/icom/
>