[HomeBrew] Homebrew tips on making "new old transmitters"

[Randy Zelick]

Hello Cal & others,

I enjoyed your post on chassis construction, and I too have assembled a 
collection of Greenlee punches. Another very valuable tool I have is a 
Whitney Jr. hand punch. Makes perfect small holes in sheet metal so long 
as you are not too far from an edge.

But this brings up a couple of questions, and perhaps you or someone else
on the list knows the answer:


1. Where can you get Greenlee punches sharpened after they have been used
a lot?

2. I got on the web and tried to find punches for panel meters. No joy. 
The only knockout punches I could find were the size for conduit, and 
these don't match panel meter diameters. Anybody distribute the panel 
meter sizes?

Thanks,

=Randy=
WB6MAI

-- 
R. Zelick				email: zelickr@pdx.edu
Department of Biology			voice: 503-725-3086
Portland State University		fax:   503-725-3888

mailing:
P.O. Box 751
Portland, OR 97207

shipping:
1719 SW 10th Ave, Room 246
Portland, OR 97201