[HomeBrew] Help!

Fri, 27 Dec 2002 22:55:08 +0000

Thanks for the tip on EAGLE, now if the "learning curve" wasn't so steep!:-) 
spent over 3 hours looking in the liraries for some common shematic symbols, 
and can't find them anywhere! my Arthritis makes stndard drafting difficult, 
otherwise I would stick with what I know...

Which Library can i find standard 2& 3 conductor phone plugs and jacks in?  
Also various ground symbols including shield grounds for audio and rf 
cables?

             Durwydd MacTara

>From: Bryan Fields <[email protected]>
>To: "Durwydd MacTara" <[email protected]>
>CC: [email protected]
>Subject: Re: [HomeBrew] Help!
>Date: Fri, 27 Dec 2002 05:07:27 -0600
>
>On Friday 27 December 2002 04:07, Durwydd MacTara wrote:
> > I need to find sotware for both printed circuit layout and schematic
> > drawing that will run on my laptop, shareware preferred.
>
>EAGLE is freeware, http://www.cadsoftusa.com/.  I have been using this for
>some time, I have evaluated quite a few free software products, but none 
>are
>as good as eagle.
>
>BTW, does anyone else find the ** HOMEBREW REFLECTOR ... ** dumb and 
>annoying?
>
>73's
>--
>Bryan Fields, KB9MCI
>____________________
>   5:02am  up  3:02,  7 users,  load average: 0.24, 0.16, 0.10
>
>Welcome to Lake Wobegon, where all the men are strong, the women are 
>pretty,
>and the children are above-average.
>		-- Garrison Keillor

_________________________________________________________________
Protect your PC - get McAfee.com VirusScan Online 
http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963