[Henry] Sick 2KD Classic

[k6xyz]

Hi Ted....have you had any success??
If so, what was the fix?

Regards

Dave Harmon
CCA 97-00535
K6XYZ[at]sbcglobal[dot]net
Sperry, Ok.

-----Original Message-----
From: henry-bounces at mailman.qth.net [mailto:henry-bounces at mailman.qth.net]
On Behalf Of n6iiu at mlode.com
Sent: Sunday, February 25, 2007 12:17 PM
To: henry at mailman.qth.net
Subject: [Henry] Sick 2KD Classic

My 2KD is acting up. When I key it with the exciter I get no output. Turning
the Load and Tune controls do not affect the meters. Depending on input
power the plate and grid meters work fine. But no output. 
Thinking it could be the relays, I swapped them for each other. No effect.
Measured 18 volts DC at the relay socket in the rear. Relays seem to key but
can't tell if both are firing. According to the schematic the imput realy is
working but not the output relay. 

Any suggestions?  Unit worked well up to now. New tubes etc. 
Oh, symptom before this was while talking, output would drop to zero and
plate meter stuck at 400 ma. Turning off the amp reset everything. Thought
it was a grid to filiment short so replaced tubes with known good ones. No
luck. 

Tnx for any help.
Ted, N6IIU
p.s. give me a phone number and I will call you if that would work better. 

73
Ted Harris, N6IIU

_______________________________________________
Henry mailing list
Henry at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/henry