[Henry] Henry 5K Power Requirements

[Dan Arney]

Jerry, Both of my 8K's run on 220V 50 Amp single phase.

For them to get rated power you have to furnish 500 watts of drive. I 
think the manual says 494!!!
I drive one of mine with a FT1000 and if loaded to the hilt will give 
about 2.5KW which is the most I have seen when one of the Henry Reps was 
working on it. I took one of my 3CX3000A7 tubes down to the factory to 
check it out and on the mule it did 8,7KW into the load bank for 10 
minutes. Off for 5  and back on did the same with no problem. My other 
unit is not hooked up and is at my shop. Probably going to sell it. Both 
have 5 band presets. Great Amps.
Hank
KN6DI