[Heathkit] Heath Power Supply HP-23B

[James M. Walker]

Ah,
Actually per your wording, that is not the AC control switch, the AC is
turned on/off from a pair of pins at the 11 pin connector. Then with the
switch you mention you set the level of the LV (= low voltage) out of
the
power supply. I would also advise # 16 wires for the 6.3/12.6 volt
lines.
Jim
WB2FCN


Ray wrote:
> 
> I have a question for anybody who might know the answer...
> Just picked up a Heath Power Supply HP-23B
> 
> The question is....The AC power switch is labeled as follows...
> 
> Left Position:
> LV
> 250DC
> 
> Right Position:
> LV
> 300DC
> 
> What is the difference between the 250 & 300 setting
> Which position should be used with HW-101?
> And what does LV Mean...
> 
> I have no manual available at this time...
> 
> Thanks,
> 73
> Ray, N6XVO
> 
> 
> _______________________________________________
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: dfischer at usol.com **
> $$ See the vintage area on the HCI web site - http://www.w9wze.org $$
> Heathkit mailing list
> Heathkit at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/heathkit