[Heathkit] HR-10B

[B Riches]

Here is a rube goldberg method that I have used.  Get two 6 volt filament 
transformers at a couple of amps 5 or so and connect the two secondaries 
together.  Connect a voltage doubler circuit to one of the secondaries, this 
should give you 250 volts or so - hook up the primaries to power the 
filaments, and connect the other primary to 120v juice.  BE CAREFULL - YOU 
CAN BE KILLED IF YOU TOUCH THE WRONG STUFF!!!

73,

Bill Riches, WA2DVU
Cape May, NJ
----- Original Message ----- 
From: Danny Allen
To: heathkit at mailman.qth.net
Sent: Friday, April 01, 2005 10:40 AM
Subject: [Heathkit] HR-10B


  I am in the process of trying to rebuild an HR-10B receiver.The receiver 
is missing the power transformer (54-122-24).So far I have tried RF Parts 
and Peter Dahl , but neither have a crossover .Can anyone offer any advise ?

  Thanks Danny AG4PR
_______________________________________________
List Administrator: Duane Fischer, W8DBF
** For Assistance: dfischer at usol.com **
$$ See the vintage area on the HCI web site - http://www.w9wze.org $$
Heathkit mailing list
Heathkit at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/heathkit