[HCARC] N5HR STATION AT RED CROSS

[John K5XA]

You forgot a climbing belt, and hard hats and gloves for the ground crew!

Just pulling your chain Harv. Good list!

> -----Original Message-----
> From: hcarc-bounces at mailman.qth.net [mailto:hcarc-bounces at mailman.qth.net]
> On Behalf Of H. Vordenbaum
> Sent: Wednesday, November 09, 2011 8:44 PM
> To: hcarc at mailman.qth.net
> Subject: [HCARC] N5HR STATION AT RED CROSS
> 
> Antenna Work
> 
> Tower: Climb and take off Thrust bearing.
> Make measurements of top
> Make template for pipe flange
> Tools: 1/2 in. ratchet wrench, wrenches; 7/16, 1/2, 9/16 in.
> Tape measure, paper, pencil
> Rope 100 ft. and pulley
> Bucket
> 
> Drill holes for pipe flange:
> Tools; Drill, corded with bits; 1/16, 3/8, 7/16 in.
> Center punch, hammer
> Ext. cord, 100 ft.
> 
> Mount pipe flange and nipple:
> Tools:  Ratchet wrench, open end wrenches
> Pipe wrench
> Bolts, nuts, lock washers; 3/8 in.
> 
> Cable work:
> Loosen coax's; label cables
> Tools:  Knife, clipper, tape, marker pen
> 
> Mount box:
> copper strap, hose clamps, de-oxit
> 
> Prepare cables:
> Cut and terminate Coax's :
> Tools: Dremel tool with cutter wheel and grinder
> Knife, soldering iron with sponge, water, vise, solder, pliers
> 
> Dress and secure cables:
> Tools: clipper, cable ties
> 
> Mount Remote Coax switch:
> Tools:  Pliers, nut drivers, tape
> 
> Mount R5 antenna:
> Tools: screwdriver, nut driver, adj. wrench
> 
> Re-label connectors inside station
> Tools: tape, color pens
> ______________________________________________________________
> HCARC mailing list
> Home: http://mailman.qth.net/mailman/listinfo/hcarc
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:HCARC at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html