[HBR] Fwd: Eddystone Three Section Variable Capacitor Question

[James Fuller]

Hi,

You might try 6-40 if the 6-32 seem almost right.

JamesF


> On Mar 14, 2014, at 2:48 PM, Whitebear1122 <whitebear1122 at comcast.net> wrote:
> 

> Looks like this post was rejected the first time so I'm resending.

> Almost embarrassed to ask this but what are the threads for the Eddystone three section variable cap that is typically used in the HBR receiver?   I just got back from ACE Hardware and could not find a screw that matched the threads.  It seems like a #6 but the threads aren't right.  I tried both US and metric.  I was planning on mounting the variable cap to the RF sub chassis, make sure everything lines up, then drill the holes for mounting the RF sub chassis on the main chassis.  
> 
> On my HBR-13 project, the main chassis is 98% drilled and milled.  The last component arrived today, an 8 section barrier strip that mounts on the rear panel and has connections for antenna, speaker, mute, and and extra pair.  RF sub chassis is all drilled and milled.  BFO chassis left to drill.  I have a plexiglass front panel drilled and milled, the Eddystone slide rule dial mounted, and the panel mounted to the chassis.  I'm figuring another week of last mechanical work and then I can start building.
> 
> 73, Scott WA9WFA

______________________________________________________________
HBR mailing list
Home: http://mailman.qth.net/mailman/listinfo/hbr
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:HBR at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html