[Hammarlund] SP-600JX-17 Mounting screw size?

[Bill]

The 3/4" length fits and I suppose 5/8" would be fine too. But still 
puzzled. The 1/4" diameter is too small, and maybe it is 3/16. If it 
uses clip nuts how does one get their hand inside?

Can someone look at one of theirs mounted in an original cabinet? Remove 
it slightly to attach?

Thank you for replies so far....good stuff but nothing definite yet.
Bill W2CQ



On 6/19/2017 1:21 PM, Paul Kraemer wrote:
> Usually those are 10-32 thread
> The coarse is 10-24
> Are the original hole deformed?  If they are you may have to use clip 
> nuts
> There is also a 12-24 screw which I think is same as typical 3/16" bolt
> Paul
>
> -----Original Message----- From: Bill
> Sent: Monday, June 19, 2017 11:38 AM
> To: Hammarlund
> Subject: [Hammarlund] SP-600JX-17 Mounting screw size?
>
> Help...
> Why can't I find the right screw size, to mount the SP-600JX-17 in an
> original cabinet? Fine thread, course thread??? I could only find a 1/4
> " screw in 1/2" and 3/4" lengths in 10-32 or fine thread. Is there a 
> 3/16th"
>
> I began to think maybe its through bolted, but no way can I get my hands
> in there...maybe there's a tool?
>
> So help! What is screw size and thread? I've had these two for years but
> never had the screws to fasten into the cabinets. They've always been in
> use but sitting in the same place. hi
>
> 73 in advance,
> Bill W2CQ
>
>
> ______________________________________________________________
> Hammarlund mailing list
> Home: http://mailman.qth.net/mailman/listinfo/hammarlund
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Hammarlund at mailman.qth.net
>
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: dfischer at usol.com **
>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>