[Hammarlund] aligning my HQ-180

[Robert Sauvan]

Hi all,
I am getting ready to align my HQ-180 and had a question about one of my 
signal generators. I have a HP-204 B signal generator and it has a 600 
ohm output. Is that a problem or do I need to step that impedance down 
to 50 ohms? This is the only generator I have that will put out a 60kc 
signal source to align my low IF. If I need to step the impedance down, 
how do I go about that, just add some resistors in line to bring it to 
50 ohms?

Thanks-Bob-W0YBS