[Hammarlund] Sweep Alignment intro.

[Bob Young]

Thanks but unfortunately I don't have a sweep RF generator, do have an 
O-scope however. Someone suggested I had too much RF going into the radio 
and I think they were right as it is much better now, found the crystal 
frequency was about 455.3, although the frequencies are still off. I also 
got reprimanded for re-aligning a receiver which was just aligned, haha! Now 
I can't figure out why the bands got "stretched" they start out close to 
correct at the low end and get progressively higher as I go up the dial. At 
elast on the single conversion bands, the 10 mhz WWV was right on (I aligned 
that again also)

Bob Young
Millbury, Ma

>From: "RJ Mattson" <rjmattson at hvi.net>
>To: "Hammarlund" <hammarlund at mailman.qth.net>
>Subject: [Hammarlund] Sweep Alignment intro.
>Date: Mon, 1 Jan 2007 23:55:08 -0500
>
>FYI
><http://pcbunn.cithep.caltech.edu/jjb/Hammarlund/if_alignment.htm>
>
>Found this site that explains the basics of sweep alignment for a 
>Hammarlund
>rcvr.
>
>73,
>bob...w2ami
>
>
>
>_______________________________________________
>List Administrator: Duane Fischer W8DBF
>** For Assistance: dfischer at usol.com **
>----
>http://mailman.qth.net/mailman/listinfo/hammarlund