[Hammarlund] HQ-145 question

[Jerry Kincade]

Don, maybe I can help. I have a couple of HQ carcasses out in the shop, I
think one of them is a 145. Even if it's not, Hammarlund used the same IF
cans in many of their HQ-xxx units. Please email me offline with the
Hammarlund part number that is stamped on the can, and a good description of
its location on the chassis.
Jerry W5KP   Mustang, OK

----- Original Message ----- 
From: "Schichler, Don" <don.schichler at PaeTec.com>
To: <hammarlund at mailman.qth.net>
Sent: Monday, June 14, 2004 1:36 PM
Subject: [Hammarlund] HQ-145 question


> Hello,
>
> I recently acquired a beat-up (but working) HQ-145 at a hamfest to use as
an
> AM receiver, and went through the alignment procedure over the weekend.
The
> only problem was that I could not adjust IF transformer T-7.  It was
> completely stuck, but after knocking some dirt out of it I got it to turn
a
> little bit in each direction.  My question is, does anybody know of a good
> way to get these unstuck, or should I just leave well enough alone?  I
would
> replace it if I knew where to find one.
>
> Thanks,
> Don K2FY
> _______________________________________________
> List Administrator: Duane Fischer W8DBF
> ** For Assistance: dfischer at usol.com **
> ----
> http://mailman.qth.net/mailman/listinfo/hammarlund
>