[Hammarlund] HQ 140 X arrives!

Rodney Bunt [email protected]
Tue, 23 Sep 2003 23:57:47 -0700 (PDT)


To get in the top, undo the two lamp holder screws, and two screws on the rear top of the cover,
you can just put back the tube holders with screws to stop things going astray.

Not a lot to see, realy, you can clean up the bushes and blades etc.

There are a couple of caps and resistors in the RF section to check but nothing special.

Good rig eh? I have a HQ-120, 129, 140, 150, 180 and a RBG-2

Rodney
VK2KTZ
 

--- Andy Bullington <[email protected]> wrote:
> Well while waiting for my HQ 129 to arrive (still waiting) I found a DOA
> HQ 140 X on E-bay with a pretty clean looking exterior so I put in a low bid on it and won it. 
> It came today and is a noble looking beast indeed....and was DOA. tubes didn't light
> up....lights didn't come on....I checked the output of the power transformer and was getting
> plenty of juice so I tried replacing the 5U4. Nope...replaced the voltage regulator and presto!!
> lights! tube glow! hideous hum! the one tube I don't have a replacement for....(of course)..the
> 12AU7 audio preamp and BFO tube
> was bad...plus there was a broken off pin from an old tube stuck in the socket. Put in a 12AY7
> and got signals galore. Need to get the right tube because the 12AY7 has too much gain and
> overloads the CW signals.
> AM sounds gorgeus though.  The under chassis looks very clean and very few paper caps. Most
> resistors I've checked so far are correct.  Now my question is this: I'd like to get in the RF
> compartment but this looks like a possibly very tricky proposition...does anybody know how to do
> this? also are there any particular caps or resistors I should check other than the
> electrolytics and paper ones? Thanks.
>                     Andy W1AWB
> 
> 
> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
>   text/plain (text body -- kept)
>   text/html
> The reason this message is shown is because the post was in HTML
> or had an attachment.  Attachments are not allowed.  To learn how
> to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
> _______________________________________________
> List Administrator: Duane Fischer W8DBF
> ** For Assistance: [email protected] **
> ----
> http://mailman.qth.net/mailman/listinfo/hammarlund


__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com