[Hammarlund] SP600-JX-17

[James A. (Andy) Moorer]

on 8/9/02 3:49 PM, lou de beer at lou.de.beer@general.com wrote:

> I have a JX-17 version and mounted on the side panel of the chassis near the
> line voltage input,are two large wirewound resistors...I don't have the
> schematic..Can someone tell me if the bare wire on the resistor furthest
> from the back apron,goes to ground?..Thanks in advance...Lou..
> 


First off, you can get the manual from my web site:

http://www.jamminpower.com/jam/main/sp600.jsp

(or, just go to http://www.jamminpower.com and then find the BOATANCHORS
page. From there, you can get to the SP-600 page)

The short answer is yes, that bare wire goes to ground.

There should be one wire that connects the two resistors (R72 and R73)
together. That connection also goes to a sorta orange-ish wire that goes
back to the IF area. The other end of one of the resistors goes to the +150
regulated, and the other end of the other resistor goes to ground.

Good luck!

The mid point between the two resistors should be close to 100 volts.


-- 
www.jamminpower.com
James A. (Andy) Moorer