[Ham-Mac] IC-7300 and Fldigi

[Terry Martin]

Hi Ron,

Many thanks for responding! You are right - I can ditch the SignaLink even though I have the correct cable and links for the 7300. With just this radio connected and the following options set, Fldigi now works:-
Menu-Set-Connectors:
	ACC/USB AF level ~50%
	USB MOD Level 25%
	DATA MOD USB
	CI-V USB Port Unlink from Remote
Then use USB-D as the mode. This seems to work!! BTW, with both devices connected, only one sound source shows up when configuring Fldigi. I can always use the SIgnaLink with my KX3 on the Macbook Pro :-)

Unfortunately, these settings still don’t activate the PTT with JT-Bridge and WSJT-X (not even with VOX on) so no idea what is going on here - any suggestions?

All the very best
	Terry, M0CLH



> On 9 Sep 2016, at 14:31, Ron 'KF5JRA' Rosson <kf5jra at oneinsane.org> wrote:
> 
> Terry,
> 
> The IC-7300 does not need the signalink, You can keep that attached to your KX3. All you need is below:
> one USB cable
> RUMLogNG properly working with the radio
> Configure FLDigi
> Select CAT to PTT
> 
> Looks like you have the rest. If you have the signalink and the 7300 hooked up at the same time you are also probably seeing two (2) USB CODECS in your sound sources. Unplug the signalink and the KX3, configure and test for operation in all modes. Keeping them connected then hookup the KX3 and configure it as TX2 test to make sure it works. At this point you will probably need to contact Tom (DL2RUM) on how does RUMLogNG work with two radios connected at the same time. (SO2R)
> 
> Hope this helps.
> --
> 73 de KF5JRA
> Ron
> 
>> On Sep 9, 2016, at 3:43 AM, Terry Martin via Ham-Mac <ham-mac at mailman.qth.net> wrote:
>> 
>> Help please!  I have just invested in the above transceiver and trying to use it with a SignaLink USB interface, fldigi and wsjt-x for data modes and iMac running OS X 10.10.5. The logging program RUMLogNG does all the CAT control together with help from JT-Bridge for the JT modes. (This combination works great with my KX3). Frequency and mode changes seem to work fine. In Fldigi, both ‘Tune’ and the macros activate the PTT BUT no power is output which kind of suggests that the audio signal is not getting to the 13 pin connector at the back of the radio. I have tried various combinations of settings on the radio but guess have not hit the right combination. Any suggestions most welcome.
>> Many thanks in anticipation,
>> 	Terry, M0CLH
>> ______________________________________________________________