[Ham-Mac] Need Help for a fldigi/K3 Interface

[Dick Kriss]

I have been trying to help Richard, N5XRD, with his K3/fldigi interface and I do not have a K3 so I could not help. If you are a K3 user, please reply to Richard N5XRD direct.

I had Dick download and install the Silicon Graphic USB to UART driver from http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx. When he opens the fldigi-3.21.76 Rig Control configuration panel, the SLAB_USBtoUART Device is not visible. Maybe the K3 uses a different device or maybe there is an issue with his recently repaired Mac by Apple?

He could use some help from a K3 user

73 Dick AA5VU
Kenwood user - never used a K3



Begin forwarded message:

> From: Richard W Hemingway <rheming1 at sbcglobal.net>
> Subject: Re: Selecting calls in fldigi
> Date: October 10, 2013 8:44:58 PM CDT
> To: Dick Kriss <aa5vu at att.net>
> Reply-To: Richard W Hemingway <rheming1 at sbcglobal.net>
> 
> Dick,
> 
> I have been using a SignalInk USB for the connection between he computer and radio.  It plugs into the radio and the cable goes into the SL.  Then it goes out of the SL and then to a USB port on the computer  It has a volume control for both TX and RX/ volume.  I have used it with the K3 for several years since I bought  it.  The RX seems to through to the computer with the volume control and it is still working fine.  The  TX control goes from the computer and usually show a PTT red llight on the SL and the red light on the K3.  However now it shows the red light  on the SL USB and the  K3 but no power is shown on the power meter on the K3 or on the separate power meter.  I am wondering if it is still working on TX?
> 
> Hope  this  helps.  It was working just fine on 9/1 my last contact, just before I took the comuter in to Apple on 10/6.  They replaced a logic board and also did some hardware labor repair, not specified.  They re-installed a new OS.
> 
> Dick
> 
>