[Ham-Mac] Re: Ham-Mac Digest, Vol 48, Issue 1

[David Ferrington, M0XDF]

I seem to be having a similar problem with my K3 (the FT-857 was fine).

If I have Auto-Tune set, quite often, the mode does not change when freq
does, but as long as the line is still highlighted in the DX-Cluster panel,
hitting 'Enter' then sets mode correctly. If I highlight a different line
and ht Enter (or double-click), same thing happens and another Enter fixes
it.

It looks like a race condition or perhaps my delay is too short or baud rate
to high (but other changes work fine).

I'd be interested if you find the same John. I don't have a problem with
Band Plans, and use the one that comes of the net.

I haven't reported my problem yet, one because I've only just switched to
the K3 and of course its really a K2 driver and two, because I haven't
exhausted all possible combos of connection config yet.


On 2/1/08 09:02, "ham-mac-request at mailman.qth.net"
<ham-mac-request at mailman.qth.net> sent:

> 2.  I can't seem to make the mode selection work for anything other
> than USB, LSB and CW.
> In particular RTTY and PKT  don't respond correctly; they select USB.
> The mode pulldown
> menu seems to work correctly, but not the mode selection that results
> from clicking on the band
> chart or double clicking on an entry in the cluster list.  I have
> tried various encodings in the
> USA.dat file,  e.g. PKT and PKTL, but they don't make any difference.

-- 
No sensible decision can be made any longer without taking into account not
only the world as it is, but the world as it will be.
-Isaac Asimov, scientist and writer (1920-1992)