[Ham-Mac] TM-D700 & Mac Powerbook G4

[Patrick Merat]

Biil,
I have used it without any problem (same setup Powerbook G4 and rig) . 
If you use a keyspan interface, the setup program will tell you which  
is the port (usually Port1).  Do not forget that you have to use a 
terminal program (I have used Z terminal with success with Mac OSX: do 
not forget to set baud rate etc: this program is available on the net 
for free) also set rig to TNC and NOT APRS otherwise it does not work.

Good luck!

73

Patrick KC2JJR



On Jul 11, 2004, at 11:35 AM, William Pierce wrote:

> I am new to this list.  Have been monitoring it for some time.
>
> Has anyone had any experience interfacing the Mac G4 to the Kenwood 
> TM-D700 ?
>
> I have a USB to Serial adaptor but don't know which com port the usp 
> port is.
>
> I would like to use the TMD700 for packet if thats possible with the 
> G4.
>
> Thanks,
>
> Bill
> kd0ju at amsat.org
>
> _______________________________________________
> Ham-Mac mailing list
> Ham-Mac at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/ham-mac