[Ham-Computers] Adding Ram into a computer

Sat Jun 10 13:55:50 EDT 2006

Brian,

Just spread the latches on ends of RAM and it will raise out. Then put back 
in til the latches pop back to sides of RAM and latch.

On older RAM the memory fell out at slant. Then it had to be put back in and 
angle and raised up til latches took hold.

Loren

If I do not dream then it can't come true!
Loren Moline WA7SKT  CN86cx
Member: ARRL, Pacific Northwest VHF Society #151

>From: "Brian K. Gaskamp" <ka5bkg at sbcglobal.net>
>Reply-To: "Computers (or other) used for amateur radio, communications,  or 
>experimenting" <ham-computers at mailman.qth.net>
>To: "Computers (or other) used for amateur radio, communications,  or 
>experimenting" <ham-computers at mailman.qth.net>
>Subject: Re: [Ham-Computers] Adding Ram into a computer
>Date: Sat, 10 Jun 2006 12:50:26 -0500
>
>I guess I'll have to open the puter up and see whats in there.
>Never done this before so learning while doing.
>
>
>----- Original Message ----- From: "Loren Moline WA7SKT" 
><lmoline at hotmail.com>
>To: <ham-computers at mailman.qth.net>
>Sent: Saturday, June 10, 2006 12:47 PM
>Subject: Re: [Ham-Computers] Adding Ram into a computer
>
>
>>Brian,
>>
>>I believe the type of chipset will determine what RAM is supported. I bet 
>>its DDR and at least 266Mhz RAM. You need to know how many sockets..how 
>>many RAM boards are installed. You may have to replace rather than just 
>>add.
>>
>>Loren
>>
>>
>>
>>If I do not dream then it can't come true!
>>Loren Moline WA7SKT  CN86cx
>>Member: ARRL, Pacific Northwest VHF Society #151
>>
>>
>>
>>
>>
>>>From: "Brian K. Gaskamp" <ka5bkg at sbcglobal.net>
>>>Reply-To: "Computers (or other) used for amateur radio, communications, 
>>>or experimenting" <ham-computers at mailman.qth.net>
>>>To: "Computers (or other) used for amateur radio, communications,  or 
>>>experimenting" <ham-computers at mailman.qth.net>
>>>Subject: Re: [Ham-Computers] Adding Ram into a computer
>>>Date: Sat, 10 Jun 2006 12:43:12 -0500
>>>
>>>1.99 Ghz
>>>
>>>
>>>----- Original Message ----- From: "Loren Moline WA7SKT" 
>>><lmoline at hotmail.com>
>>>To: <ham-computers at mailman.qth.net>
>>>Sent: Saturday, June 10, 2006 12:34 PM
>>>Subject: Re: [Ham-Computers] Adding Ram into a computer
>>>
>>>
>>>>Hello Brian,
>>>>
>>>>If your going to increase the RAM you will have to open the computer 
>>>>anyway. The RAM is either DRAM or DDR and you may be able to just take 
>>>>one out of the socket and see the frequency and the number of pins will 
>>>>tell you if its DRAM or DDR. What is your processor freq?
>>>>
>>>>Loren
>>>>
>>>>
>>>>
>>>>If I do not dream then it can't come true!
>>>>Loren Moline WA7SKT  CN86cx
>>>>Member: ARRL, Pacific Northwest VHF Society #151
>>>>
>>>>
>>>>
>>>>
>>>>
>>>>>From: "Brian K. Gaskamp" <ka5bkg at sbcglobal.net>
>>>>>Reply-To: "Computers (or other) used for amateur radio, communications, 
>>>>>or experimenting" <ham-computers at mailman.qth.net>
>>>>>To: "Computers (or other) used for amateur radio, communications,  or 
>>>>>experimenting" <ham-computers at mailman.qth.net>
>>>>>Subject: Re: [Ham-Computers] Adding Ram into a computer
>>>>>Date: Sat, 10 Jun 2006 12:24:55 -0500
>>>>>
>>>>>Hmmm, I guess I'll have to find the manual and do some searching.
>>>>>
>>>>>
>>>>>----- Original Message ----- From: "Dale Miller" 
>>>>><stpatrick3 at twlakes.net>
>>>>>To: "Computers or other used for amateur radio communications or 
>>>>>experimenting" <ham-computers at mailman.qth.net>
>>>>>Sent: Saturday, June 10, 2006 12:21 PM
>>>>>Subject: Re: [Ham-Computers] Adding Ram into a computer
>>>>>
>>>>>
>>>>>>If you know your motherboard model, the manual will tell you what 
>>>>>>memory is compatible with it.
>>>>>>If you dont' have the manual, it can be gotten at the motherboard 
>>>>>>manufacturer's site.
>>>>>>
>>>>>>
>>>>>>--
>>>>>>All the Best & 73's
>>>>>>Dale Miller, KC2CBD
>>>>>>Tennessee
>>>>>>Ham Operator since 1997
>>>>>>Member of YahooPipesmokers and ASP since February 2005
>>>>>>
>>>>>>stpatrick2spam at twlakes.net
>>>>>>stpatrick3spam at twlakes.net
>>>>>>stpatrick3spam at gmail.com
>>>>>>
>>>>>>(cut the spam to reply)
>>>>>>
>>>>>>
>>>>>>VOTE TO REBUILD!
>>>>>>www.twintowersalliance.com
>>>>>>
>>>>>>---
>>>>>>
>>>>>>
>>>>>>
>>>>>>Brian K Gaskamp wrote:
>>>>>>>I have been thinking of adding some ram into the system here, but how 
>>>>>>>do I know what type I need, etc.
>>>>>>>
>>>>>>>Do I have to open the case up, or is there somewhere within the 
>>>>>>>system here that will tell me exactly what I need.
>>>>>>>
>>>>>>>73,
>>>>>>>Brian
>>>>>>>
>>>>>>>______________________________________________________________
>>>>>>>Ham-Computers mailing list
>>>>>>>Home: http://mailman.qth.net/mailman/listinfo/ham-computers
>>>>>>>Help: http://mailman.qth.net/mmfaq.html
>>>>>>>Post: mailto:Ham-Computers at mailman.qth.net
>>>>>>>
>>>>>>
>>>>>>______________________________________________________________
>>>>>>Ham-Computers mailing list
>>>>>>Home: http://mailman.qth.net/mailman/listinfo/ham-computers
>>>>>>Help: http://mailman.qth.net/mmfaq.html
>>>>>>Post: mailto:Ham-Computers at mailman.qth.net
>>>>>>
>>>>>
>>>>>
>>>>>______________________________________________________________
>>>>>Ham-Computers mailing list
>>>>>Home: http://mailman.qth.net/mailman/listinfo/ham-computers
>>>>>Help: http://mailman.qth.net/mmfaq.html
>>>>>Post: mailto:Ham-Computers at mailman.qth.net
>>>>
>>>>
>>>>______________________________________________________________
>>>>Ham-Computers mailing list
>>>>Home: http://mailman.qth.net/mailman/listinfo/ham-computers
>>>>Help: http://mailman.qth.net/mmfaq.html
>>>>Post: mailto:Ham-Computers at mailman.qth.net
>>>>
>>>
>>>
>>>______________________________________________________________
>>>Ham-Computers mailing list
>>>Home: http://mailman.qth.net/mailman/listinfo/ham-computers
>>>Help: http://mailman.qth.net/mmfaq.html
>>>Post: mailto:Ham-Computers at mailman.qth.net
>>
>>
>>______________________________________________________________
>>Ham-Computers mailing list
>>Home: http://mailman.qth.net/mailman/listinfo/ham-computers
>>Help: http://mailman.qth.net/mmfaq.html
>>Post: mailto:Ham-Computers at mailman.qth.net
>>
>
>
>______________________________________________________________
>Ham-Computers mailing list
>Home: http://mailman.qth.net/mailman/listinfo/ham-computers
>Help: http://mailman.qth.net/mmfaq.html
>Post: mailto:Ham-Computers at mailman.qth.net