[Hallicrafters] HT-32B Trans

[Robert Sauvan]

I will take a stab at this, but Im thinking this may be a connection to 
monitor your cw with the receiver so as not to have to have an external 
cw monitor. The 10 ohm pot is being used to adjust the volume of your 
monitored signal. Someone else could correct me if needed.

Bob-W0YBS


On 5/30/2014 11:02 AM, Wilson Curtis wrote:
> Looking for some clarification.
> Page 3 of the Hallicrafters' HT-32B manuel.
> Figure 3. Application For Accessory Relay Contacts
> The receiver on the left shows the SX-100, SX-101 & SX-115
> Center shows the HT-32B
> My question relates to the connection shown between pin 4 on the receiver outlet and pin 7 of the HT-32B outlet. It also shows a 10 K ohm pot connected to the wire between the receiver and transmitter : i.e."RF Gain Set for Desired Level When Monitoring CW Transmission"
> What exactly is the purpose of this connection?
> Thanks.
> Reg Curtis - VE9RWC/KB1WCP............................................................................................... 		 	   		
> ______________________________________________________________
> Hallicrafters mailing list
> Home: http://mailman.qth.net/mailman/listinfo/hallicrafters
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Hallicrafters at mailman.qth.net
>
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: dfischer at usol.com **
>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>