[Hallicrafters] SR-150 Question

[w4awm at aol.com]

Is it possible that the knob was removed at some point and not reinstalled with the shaft in the "12 o'clock position, ie: properly set so that the RIT is at zero when the knob is reinstalled?.
  73,
John,  W4AWM







-----Original Message-----
From: Richard Donley <donley.dn at comcast.net>
To: hallicrafters at mailman.qth.net
Sent: Wed, May 5, 2010 12:40 am
Subject: [Hallicrafters] SR-150 Question


Tell me if my understanding of the RIT control is as follows:
With the RIT pot knob at 12 o'clock, I should be able to turn the RIT function 
n and off without changing the receive frequency. Then I should have equal 
eceive frequency adjustment on either side of the 12 o'clock position.
My SR-150 RIT function is not centered. My RIT pot knob has to be at about 9 
'clock to have the receive frequency remain the same with the RIT on or off.