[Hallicrafters] Wrenches to remove knobs from SX 100

[Roger (K8RI)]

I think they may be a standard spline. I use the long,  Xcelite sets of 
spline and Allen wrenches. Often it takes a shot of "PB Blaster" that 
has set for a few hours so I don't strip out the insides of the screws.

73

Roger (K8RI)

John King wrote:
> I need to remove the knobs and front panel from my SX 100. I note that the screws in the large knobs are larger than the screws in the  small knobs. They look like screws that require Bristol wrenches. Is that correct and  is there a recommended source for the correct set?
>
> Does anyone  have suggestions for getting the nuts off the switches and controls on the SX 100 front panel without damaging the front panel? Suggestions appreciated. 73, John, K5PGW
>
>
>
>       
> ______________________________________________________________
> Hallicrafters mailing list
> Home: http://mailman.qth.net/mailman/listinfo/hallicrafters
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Hallicrafters at mailman.qth.net
>
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: dfischer at usol.com ** 
>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>