[Hallicrafters] SX101

[Bill Campbell]

I have a SX101 that needs a complete alignment.  I have replaced all the
paper caps and replaced tubes as necessary.  Receives well on the lower
bands but sensitivity decreases rapidly as frequency goes up. Hence the need
for alignment.  I have a SIG-103/URM-25F signal generator which will go down
to the 50.5 kc IF that is needed.  I have reviewed the manual for the proper
procedure which seems rather straight forward.  However,  I have never
aligned a receiver, much less one as complex as the 101.  If those of you
who have done a 101 can give me any hints, kinks or cautions I would
appreciate hearing from you.  This is a very nice radio and I want to do the
best job possible.  Also, have a nice working HT32A to go with it. It will
be a next recap job.  Thanks in advance.

Bill - WD4HEN