[Hallicrafters] Re: SX-28A

[Mike]

Greetings all

It is actually not too hard to align all of the wafers within the SX-28A or SX-28 bandswitch assembly. If you take a look at the hole in the wafers that the bandswitch shaft goes through you will notice that it is actually a square with two rounded ends on it. On one of those flat sides you will notice a little dimple. Keep these dimples aligned on the same side of the shaft as you replace it and you will have no problem. Hope this helps.

best regards
Mike Smout VA3DPO
Sarnia, Ontario, Canada


--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment.  Attachments are not allowed.  To learn how
to post in Plain-Text go to: http://www.expita.com/nomime.html  ---