[Hallicrafters] SX=28

[jackiv at juno.com]

Note, when turning over a set as heavy as the -28 always plan ahead.
usually a 
solder spool under the pwr tx on the 28 is enough to preserve the rec
tube.
make up a 4 pin tube base, solder in a few 1N4007 diodes, two in series
 each leg. good test tool too.  reduces the tx load by 15 watts  jack  
  jackiv at juno.com


On Sat, 5 Jul 2003 09:13:41 -0700 "Judith" <ehrlich at olypen.com> writes:
> Frank,
> 
> Yes, by all means replace the 5Z3 with a pair of diodes.  Place a 
> resistor
> in series with each diode to drop the voltage to a level similar to 
> that
> which you have while using the 5Z3.  

----------------snip-----------------------