[GreenKeys] 28 ASR Motor

[Tom Hunter]

John,

The motor is flaky starting. It will wobble back and forth a few degrees
and overheat if I  don't cut the power.

If I give it a spin and quickly turn on the power, it runs fine.

The first thing I did months ago was clean the relay. It worked fine on the
bench but went back to wobbling in the ASR. Recently I bought a new
outboard capacitor. It worked fine for a week or two then it started to
wobble again.

By now I had a used LMU12 which I swapped in.he ASR has been fine since.

Now that it would run reliably, I could tackle the uneven printing. That
turned out to be both vertical correcting levers slightly bent.

I put the flaky LMU12 in a 28 ASR base I will be using soon. If it still
acts up I will worry about it then.

Thank you  for your interest.


Tom    N3CRK
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20211117/a652149d/attachment.html>